Leon Mk2
Removing and installing sealing flange and flywheel |
Note!
t | Servicing the clutch: |
t | → 5-Speed manual gearbox 085; Rep. Gr.30 |
1 - | Oil seal |
q | Renewing → Chapter |
2 - | 25 Nm |
3 - | Front sealing flange |
q | Must be located on dowel sleeves |
4 - | Gasket |
q | Renew |
5 - | Cylinder block |
q | Removing and installing crankshaft → Chapter |
q | Dismantling and assembling pistons and conrods → Chapter |
6 - | 60 Nm + 1/4 turn (90 °) further |
q | Renew |
q | The quarter turn further can be done in several stages. |
q | The turning further angle can be measured with protractor -T20030- |
7 - | Flywheel |
q | To remove and install hold flywheel with counter-hold -T20075- |
8 - | Intermediate plate |
q | Must be located on dowel sleeves |
q | Do not damage/bend when assembling |
9 - | 10 Nm |
10 - | Sealing flange with oil seal |
q | Only renew complete |
q | Lightly oil sealing lip of oil seal |
11 - | Intermediate shaft |
12 - | O ring |
q | Renew if damaged |
13 - | Sealing flange intermediate shaft |
14 - | Oil seal |
q | Remove to remove sealing flange |
q | Install with oil seal fitting tool U-30002 |
q | Lightly oil sealing lip |