When working on the fuel supply/injection system, pay careful attention to the following “6 rules”: |
t
| Thoroughly clean all unions and the adjacent areas before disconnecting. |
t
| Place parts that have been removed on a clean surface and cover. Do not use fluffy cloths! |
t
| Carefully cover opened components or seal, if the repair cannot be carried out immediately. |
t
| Only install clean components: Only unpack replacement parts immediately prior to installation. Do not use parts that have been stored loose (e.g. in tool boxes etc.). |
t
| When the system is open: Do not work with compressed air if this can be avoided. Do not move vehicle unless absolutely necessary. |
t
| Also ensure that no Diesel fuel runs onto the coolant hoses. If necessary hoses must be cleaned immediately. Affected hoses must be replaced. |
|
|
|