Leon Mk2
| Ignition system, bodywork side removing and installing |
| 1 - | Radiator |
| q | Separating and fitting → Chapter. |
| q | After replacing, renew all coolant |
| 2 - | O-ring |
| q | Replace if damaged or worn |
| 3 - | Upper coolant hose |
| q | Secured to radiator with retaining clip |
| q | Ensure tight fit |
| q | Coolant hose connection diagram → Chapter |
| 4 - | Air duct |
| 5 - | 10 Nm |
| 6 - | Additional fan |
| q | Only vehicles with optional equipment |
| 7 - | Support |
| q | According to versions |
| 8 - | Securing clip |
| q | Ensure tight fit |
| 9 - | Connector |
| q | According to versions |
| 10 - | Radiator fan -V7- |
| q | Checking → Chapter |
| 11 - | To thermostat housing |
| q | Coolant hose connection diagram → Chapter |
| 12 - | Expansion tank |
| q | Cooling system leakage: checking with cooling system tester SAT 1274 and adaptors -V.A.G 1274/8- and -V.A.G 1274/9- → Chapter |
| 13 - | Cap |
| q | Pressure relief valve: checking with tester -SAT 1274- and adapter -V.A.G 1274/9- → Chapter |
| q | Test pressure: 1,4 … 1,6 bar |
| 14 - | Support |
| q | For the fan connectors |
| 15 - | Lower coolant hose |
| q | Secured to radiator with retaining clip |
| q | Ensure tight fit |
| q | Coolant hose connection diagram → Chapter |
| 16 - | O-ring |
| q | Replace if damaged or worn |
| 17 - | Thermoswitch -F18-, 35 Nm |
| q | For the radiator fan |
| q | Switching temperatures: |
| 1a speed |
| q | Connected: 92 … 97 °C |
| q | Disconnected: 84 … 91 °C |
| 2a speed |
| q | Connected: 99 … 105 °C |
| q | Disconnected: 91 … 98 °C |
| 18 - | Support |
| q | For radiator |
| q | Note the fitting position |
| q | Note that there are different versions |
| 19 - | 10 Nm |
