–
| Insert the coupling -T20081B/2- over the oil pump retainer and carefully guide the pump over the crankshaft drive cams. |
–
| Align inner rotor to crankshaft follower polygon cams by turning slightly if necessary. |
–
| Then carefully connect the oil pump onto the guide anchor bolts. |
–
| Attach the oil pump with new bolts, do not put the longest bolts into place until the lower protector for the ribbed belt has been put into place Tightening torque: 12 Nm |
–
| Pull out sleeve -T10081B/2-. |
–
| Install induction pipe. |
The rest of the assembly is basically a reverse of the dismantling sequence. |
–
| Assemble the pinion for the ribbed belt and the tightener roller, Ribbed belt, assemble, tighten: → Chapter. |
|
|
|