Leon Mk2
| Part II |
Note!| Servicing the clutch → Rep. Gr.30. |
| 1 - | Cylinder block |
| q | Dismount and assemble aluminium cylinder block → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 2 - | 50 Nm |
| q | Renew |
| q | Tightening sequence: Upper right bolt first, then lower right bolt, and bolts on left last (as seen from direction of travel) |
| 3 - | Oil filter |
| q | Loosen on hexagon |
| q | Tighten by hand |
| q | Note instructions on filter when installing |
| 4 - | Compact bracket |
| q | For vane pump and alternator |
| 5 - | 15 Nm |
| q | Loosen and tighten the bolts on the wheel side with the Allen key -U-40051A- |
| 6 - | Sump |
| q | Removing and installing → Chapter |
| 7 - | Oil drain plug, 30 Nm |
| q | With attached seal |
| q | Renew |
| 8 - | M8: 20 Nm + 1/4 turn (90 °) further |
| q | Renew |
| q | The turning further can be done in several stages |
| q | The turning further angle can be measured with protractor -T20030- |
| 9 - | 45 Nm |
| 10 - | Washer |
| 11 - | Tensioning roller |
| 12 - | Tensioning element |
