–
| Connect vehicle diagnosis, testing and information system -VAS 5051- as follows: |
–
| Fit connector from diagnosis cable -VAS 5051/1- or -VAS 5051/3- to diagnosis connection. |
–
| Start engine and run at idling speed. |
Only if engine does not start: |
–
| Press button for “Vehicle self-diagnosis” on display. |
–
| Press button “01 - Engine electronics” on display. |
The control unit identification and coding are indicated on the display. |
Select diagnostic function |
–
| Press button “02 - Interrogate fault memory” on display. |
If no fault is stored in engine control unit “0 fault(s) detected” is displayed. |
If faults are stored in the engine control unit, these are shown one below the other on the display. |
–
| Press button “05 - Erase fault memory” on display. |
–
| Press function “06 - End output”. |
|
|
|