Leon Mk2
| Part II |
| 1 - | Sealing plug, 40 Nm |
| q | Replace |
| 2 - | Seal |
| q | Captive, threaded in → Item |
| 3 - | Spring |
| q | For pressure relief valve, approx. 4 bar |
| 4 - | Piston |
| q | For pressure relief valve, approx. 4 bar |
| 5 - | Gasket |
| q | Renew |
| 6 - | Non-return valve, 8 Nm |
| 7 - | Seal |
| q | Fit onto sealing cap shoulder → Item |
| 8 - | Sealing cap |
| 9 - | Retaining clip |
| 10 - | Sealing plug, 15 Nm |
| 11 - | Seal |
| q | If sealing ring is leaking nip open and replace |
| 12 - | 1.4 bar oil pressure switch -F1-, 25 Nm |
| q | Black |
| q | Checking → Chapter |
| 13 - | Seal |
| q | If sealing ring is leaking nip open and replace |
| 14 - | Oil filter bracket |
| 15 - | 15 Nm + 1/4 turn (90°) further |
| q | Renew |
| 16 - | Gasket |
| q | Renew |
| q | Fit into groove on oil cooler |
| 17 - | Oil cooler |
| q | Ensure clearance to adjacent components |
| q | See note → Chapter |
| 18 - | 25 Nm |
| 19 - | Oil filter |
| q | Loosen using the -U-40078- tool or a universal extractor |
| q | Tighten by hand |
| q | Observe installation instructions on oil filter |
