seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Piston and connecting rod: disassembly and assembly > < Removing and installing front sealing flange

Leon Mk2

Removing and installing drive plate
Removing and installing drive plate
Special tools and workshop equipment required
   
t  Counter-hold tool -T20064-
t  Depth gauge
Loosening and tightening drive plate
  W00-2345
–  Fix the counter-support -T20064- to the drive plate.
–  Loosen the screws that hold the drive plate.
Installing drive plate
  E13-0019
–  Locate drive plate and packing plate with recesses -1-.
–  Fit new bolts -3- and tighten to 30 Nm.
  V13-0991
–  Check dimension -a- at three points and calculate average.
   Specification: 19,5 … 21,1 mm
  Note!
Measured through hole in drive plate to milled surface of cylinder block.
If the specification is not attained:
  V13-0992
–  Remove drive plate again and fit shim -2-. Again tighten bolts -3- to 30 Nm.
–  Tighten bolts -3- to 60 Nm and turn 90° (1/4 turn) further (turning further can be done in several stages).
  V13-0991

Piston and connecting rod: disassembly and assembly > < Removing and installing front sealing flange