Leon Mk2
Part II (engine code letters: APF, AUR) |
1 - | Hot air pick up plate |
2 - | 25 Nm |
3 - | 6-pin connector |
q | Black, for lambda probe 1 before catalyst -G39- and lambda probe heating -Z19- |
q | On the rear engine support, on the right |
q | Golden contacts |
4 - | Lambda probe 1 before the catalyst -G39-, 50 Nm |
q | Constant Lambda probe |
q | Just grease the thread with -G 052 112 A3-. The -G 052 112 A3- should not be in contact with the grooves in the body of the probe |
q | Remove and install with -U-40080- |
5 - | Of the combined valve |
q | Secondary air system → Item |
6 - | Threaded connector, 35 Nm |
7 - | 25 Nm |
8 - | Union pipe |
q | Secondary air system → Chapter |
9 - | 25 Nm |
10 - | 4 Nm |
11 - | Clamp |
q | According to versions |
12 - | Flange |
q | To fasten the union pipe to the exhaust gas recirculation valve |
13 - | 25 Nm |
q | Replace |
14 - | 4-pin connector |
q | Brown |
q | Contacts 3 and 4 golden |
q | For lambda probe and lambda probe heating |
15 - | 60 Nm |
16 - | Lambda probe 2 after the catalyst -G130-, 50 Nm |
q | Just grease the thread with -G 052 112 A3-. The -G 052 112 A3- should not be in contact with the grooves in the body of the probe |
q | Remove and install with -U-40080- |
17 - | To the central silencer |
18 - | Front exhaust pipe with catalyst |
19 - | 40 Nm |
q | Replace |
20 - | 25 Nm |
21 - | Support |
22 - | 20 Nm |
q | Replace |
23 - | Seal |
q | Replace |
24 - | Exhaust manifold |
25 - | Seal |
q | Replace |
26 - | Support |
27 - | Washer |
q | If there is a collar nut, there is no washer |
28 - | 25 Nm |
q | Replace |
29 - | 10 Nm |
30 - | To the throttle valve control unit -J338- |
31 - | 25 Nm |
32 - | Union pipe |
q | Exhaust gas recirculation system → Item |