Leon Mk2
Removing and installing parts of the ignition system |
1 - | H.T. cable |
q | With suppression connector and spark plug connector |
q | Check for continuity |
2 - | Ignition coils (-N-, -N128-) |
q | Marked for H.T. cables: |
A = Cylinder 1 |
B = Cylinder 2 |
C = Cylinder 3 |
D = Cylinder 4 |
q | With output stage -N122- |
3 - | 10 Nm |
4 - | Connector |
q | 4 pin |
5 - | Knock sensor 1 -G61- |
q | Sensor and connector contacts are gold-plated |
6 - | 3 pin connector |
q | Contacts gold plated |
q | Black |
7 - | 20 Nm |
q | Tightening torque influences the function of the knock sensor |
8 - | Spark plug, 30 Nm |
q | Type and electrode gap → Chapter |
q | To remove and install pull off the connectors for the outer injectors |
q | Remove and install with -U-30037- |
9 - | Connector |
q | Sensor and connector contacts are gold-plated |
q | 3 pin |
10 - | Bracket |
q | For Hall sender |
11 - | Hall sender -G40- |
12 - | Camshaft sprocket |
q | With rotor for Hall sender |
q | Removing and installing → Chapter |
13 - | 10 Nm |
14 - | 100 Nm |
q | Counter-hold with -T20018- to loosen and tighten |