seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing crankshaft > < Installing

Leon Mk2

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
   
t  Counter-hold -T20075A-
Removing
–  Mark installation position of twin mass flywheel to crankshaft using a waterproof felt tip pen.
  W00-2998
–  Insert counter-hold -T20075A- into hole in cylinder block and lock onto twin mass flywheel.
–  Remove flywheel bolts.
Installing
–  Install twin mass flywheel on crankshaft in the position as marked previously when removing.
–  Tighten new securing bolts. Tightening torque: 60 Nm + 1/4 turn (90°) further
  E13-0119

Removing and installing crankshaft > < Installing