Leon Mk2
| Removing and installing cylinder head |
| Checking compressions → Chapter. |
Note!| t | When installing a spare/exchange cylinder head, all the contact surfaces between the support elements, roller rocker arms and the cam contact surfaces must be oiled before installing the camshaft housing. |
| t | The plastic packing pieces for protecting the open valves must not be removed until immediately before fitting cylinder head. |
| t | If the cylinder head is replaced, all the coolant in the system must also be renewed. |
| t | Removing and installing intake manifold → Chapter, parts of injection system. |
| 1 - | 6 Nm + 1/4 turn (90°) further |
| q | Renew |
| q | Observe installation instructions and sequence when loosening and tightening → Chapter |
| 2 - | Screening cover |
| q | Ensure installation position |
| q | It is taken out and fitted again |
| 3 - | Coupling |
| q | Replace in the event of damage |
| 4 - | Cap |
| q | Replace the seal if it is damaged |
| 5 - | Cylinder head cover |
| q | Sealing surfaces must not be worked |
| q | With integrated camshaft bearings |
| q | Removing and installing → Chapter |
| q | Remove remnants of old sealant |
| q | Coat with -AMV 154 103- before fitting |
| q | When installing, insert vertically from above with dowel pins into holes of cylinder head |
| 6 - | 10 Nm |
| 7 - | Bracket |
| q | For main collective connector |
| 8 - | Dowel pin |
| 9 - | Camshaft |
| q | Checking axial clearance → Fig. |
| q | Identification and timing → Anchor |
| q | Oil contact surface |
| q | Removing and installing → Chapter |
| 10 - | 20 Nm |
| 11 - | Cylinder head bolt |
| q | Renew |
| q | Note installation instructions and sequence when loosening and tightening → Chapter |
| 12 - | Lifting eye |
| 13 - | Cylinder head |
| q | Check for distortion → Fig. |
| q | After replacing renew the complete coolant |
| q | Reworking the sealing surface on the camshaft side is not permitted |
| q | Removing and installing → Chapter |
| 14 - | Support element |
| q | Do not interchange |
| q | With hydraulic valve clearance compensation |
| q | Check camshaft axial clearance before installing → Fig. |
| q | Oil contact surface |
| 15 - | Retaining clip |
| 16 - | Floating roller arm |
| q | Check bearing for ease of movement |
| q | Oil contact surface |
| q | Use securing clip to clip onto support element when installing |
| 17 - | Cylinder head gasket |
| q | Metal gasket |
| q | Renew |
| q | If replaced renew the complete coolant |
| 18 - | Retainer |
| q | Lightly oil sealing lip of oil seal |
| q | Renew → Chapter |
|
|