–
| Install tensioning roller and tighten securing bolt hand-tight. The slot in the base plate -1- must locate around securing bolt -2-. |
–
| Tension toothed belt by turning the tensioning roller in direction of arrow until the indicator -3- aligns with the groove in the base plate -arrow-. |
–
| Tighten clamping the bolt/nut on tensioning roller. Tightening torque: 20 Nm |
–
| Now turn the crankshaft two turns in engine direction of rotation until it is again at top dead centre No. 1 cylinder. |
–
| Now the position of the toothed belts and tensioning roller must be checked again. |
–
| Install toothed belt guard upper and lower parts. |
–
| Install belt pulley (note fixing arrangement). Tightening torque: 20 Nm |
Note! When assembling the ribbed belt, make sure that it is properly housed in the pulleys. |
–
| Install air cleaner → Chapter, Dismantling and assembling air cleaner. |
|
|
|