–
| Pull breather pipe/hose -2- from activated charcoal filter -1- off at throttle valve control part -3-. |
–
| Connect hand vacuum pump -SAT 1390- to hose/pipe -2-. |
–
| Pull breather hose/pipe -5- off fuel tank to activated charcoal canister and connect to vacuum tester -V.A.G 1368-“connection A”. Use Adapter -SAT 1368/1- when doing this. |
–
| Connect vacuum tester -V.A.G 1368-“connection B” with breather hose/pipe -4- to activated charcoal canister. Use Adapter -SAT 1368/1- when doing this. |
–
| Set vacuum tester to position “B”. |
–
| Work the manual vacuum pump -SAT 1390- several times. No pressure reduction must be caused. |
–
| Check the breather connection -6- for the active carbon tank -1- for dirt; where necessary, clean it. |
If vacuum does not build-up: |
–
| Remove fuel filler cap. |
|
|
|