Installing is basically in the reverse order but note following: |
t
| Put the flexible tubes for bleeding and fuel into place without any bends. |
t
| Fit the flexible fuel pipes into place with steel strip clamps. |
t
| Check that the flexible fuel pipes are firmly fitted into place. |
t
| Do not interchange supply and return hose (return hose blue or blue markings, supply hose black). |
Note! After installing fuel gauge sender, check that the supply, return and breather pipes are still clipped onto the fuel tank. |
–
| Carry out test drive and read fault memories of all control units again. |
|
|
|