Leon Mk2
Assembly diagram |
1 - | Upper toothed belt guard |
2 - | Toothed belt |
q | Check for wear |
q | Do not kink |
q | Removing, installing and tensioning → Chapter |
3 - | 20 Nm + 1/4 turn (90°) |
q | Renew |
4 - | Camshaft sprocket |
q | Note position when installing the toothed belt → Chapter |
5 - | 10 Nm |
q | Fit with D6 |
6 - | Rear toothed belt guard |
7 - | Cylinder head cover: 5 Nm + 1/4 turn (90°); Toothed belt guard: 10 Nm |
q | Always replace the cylinder head cover securing bolts |
8 - | Sealing washer |
q | Renew |
9 - | Cap |
q | Renew seal if damaged |
10 - | Cylinder head cover |
11 - | Cylinder head cover gasket |
q | Renew if damaged |
q | Before positioning, lubricate the path areas between the caps/cylinder head with -D 454 300 A3- |
12 - | Cylinder head bolt |
q | Renew |
q | Sequence for loosening and tightening → Chapter, Cylinder head: removing and installing |
13 - | Cylinder head |
q | Check for distortion → Fig. |
q | Removing and installing → Chapter |
q | If replaced, renew all the coolant |
14 - | Cylinder head gasket |
q | Renew |
q | Metal gasket |
q | If replaced, renew all the coolant |
15 - | Tensioning roller |
q | Tighten the toothed belt → Chapter |
16 - | 20 Nm |
17 - | Pulley |
q | When installing note fixing arrangement |
q | Note position when installing toothed belt → Chapter |
18 - | 20 Nm |
19 - | Ribbed belt |
q | Mark the direction of rotation before removing |
q | Removing and installing → Chapter |
20 - | Lower toothed belt guard |
|