Leon Mk2
| Part III |
Note!| For repairs to the clutch: → 5-speed manual gearbox 085; Rep. Gr.30. |
| 1 - | Cylinder block |
| q | Cylinder block, crankshaft and flywheel: dismantling and assembling → Chapter |
| q | Piston and conrod: dismantling and assembling → Chapter |
| 2 - | 45 Nm |
| q | Tightening sequence: |
| Upper right bolt first, then lower right bolt, and bolts on left last (as seen from direction of travel) |
| 3 - | Oil filter |
| q | Loosen via the hexagon or using turning tool -U-40078- |
| q | Tighten manually |
| q | Note instructions printed on filter when installing |
| 4 - | 20 Nm + 1/4 turn (90°) |
| q | Renew |
| 5 - | 15 Nm |
| q | Loosen and tighten the bolts on the steering wheel side with -U-40051A- spanner |
| 6 - | Sump |
| q | Removing and installing → Chapter |
| 7 - | O-ring |
| q | Renew |
| 8 - | Oil drain screw |
| q | 30 Nm |
| q | In versions with captive O-ring, nip open and replace the O-ring |
| 9 - | Support |
| q | For vane pump and alternator |
| 10 - | 45 Nm |
| 11 - | Washer |
| 12 - | Tensioning roller |
| 13 - | Tensioning element |
