Leon Mk2
Part II |
1 - | Cylinder head cover |
q | Before fitting, coat transition points on cylinder head/bearing cover and the half-moon shaped cut-out with -D 454 300 A3- |
2 - | Bolt |
q | 10 Nm |
q | Tighten from inside to outside |
3 - | Ignition/HT. cable cover |
4 - | Retainer |
q | For ignition/HT. cable cover |
5 - | Cylinder head bolt |
q | Renew |
q | Observe assembly instructions and sequence when loosening and tightening → Chapter |
6 - | Cylinder head |
q | Removing and installing → Chapter |
q | When renewing renew entire coolant |
7 - | Cylinder head gasket |
q | Renew |
q | Metal gasket |
q | When renewing renew entire coolant |