Leon Mk2
Note
|
| 1 - | Oil pump |
| q | Removing and fitting → Chapter |
| 2 - | 15 Nm |
| 3 - | Chain sprocket |
| q | For oil pump drive |
| 4 - | Bearing caps 1, 2, 4 and 5 |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove. |
| q | Do not interchange used bearing shells (mark). |
| 5 - | 65 Nm + 1/4 vuelta (90°) |
| q | Replace |
| q | Continuous screw thread |
| q | Tighten to 65 Nm in order to measure radial play of the crankshaft |
| 6 - | Bearing cover |
| q | Bearing cap 1: Pulley side |
| q | Bearing cap 3 with rebates for the thrust washers |
| q | Bearing shell retaining lugs (cylinder block/bearing cap) must be on the same side. |
| 7 - | Bearing shell 3 |
| q | For bearing cap without oil groove. |
| q | For cylinder block with oil groove. |
| q | Do not interchange used bearing shells (mark). |
| 8 - | Sender wheel |
| q | Replace → Fig. |
| q | For engine speed sender -G28- |
| q | Installation is only possible in one position - the holes are distributed asymetrically |
| 9 - | 10 Nm + 1/4 vuelta (90°) |
| q | Replace |
| 10 - | Thrust ring |
| q | For bearing cap, bearing 3 |
| q | Note attachment |
| 11 - | Crankshaft |
| q | Axial play, new: 0,07 ... 0,23 mm Wear limit: 0.30 mm |
| q | Check the radial play using a Plastigage: 0,01 ... 0.04 mm Wear limit: 0.15 mm |
| q | When measuring the radial play, do not rotate the crankshaft |
| q | Crankshaft dimensions → Chapter |
