Leon Mk2
| Ignition system: removing and fitting. |
| 1 - | Connector |
| q | Black, 4 contacts |
| 2 - | Ignition coil with output stage (-N70-, -N127-, -N291-, -N292-) |
| q | Testing → Chapter |
| q | Removing and fitting → Chapter |
| 3 - | Spark plug, 30 Nm |
| q | Remove and install with wrench -T20175- |
| q | Type and spark gap → Chapter |
| 4 - | Connector |
| q | Gold plated contacts |
| q | For Knock sensor I -G61- and Knock sensor II -G66- |
| 5 - | 20 Nm |
| q | Tightening torque affects the knock sensor function |
| 6 - | Knock sensor I -G61- |
| q | Sensor and connector contacts are gold-plated |
| q | The contact surfaces of the knock sensor and cylinder block must be clean and free of grease |
| q | Testing → Chapter |
| 7 - | Knock sensor II -G66- |
| q | Sensor and connector contacts are gold-plated |
| q | The contact surfaces of the knock sensor and cylinder block must be clean and free of grease |
| q | Testing → Chapter |
| 8 - | Connector |
| q | Black, 3 contacts |
| q | For Hall sender -G40- |
| 9 - | 10 Nm |
| 10 - | Hall sender -G40- |
| q | Testing → Chapter |
| 11 - | 25 Nm |
| 12 - | Washer |
| q | Conical |
| 13 - | Shutter |
| q | For Hall sender -G40- |
| q | Note location when installing |
| 14 - | Earth cable |
| q | Tighten or loosen only when the ignition is off |
| 15 - | 10 Nm |
| q | Tighten or loosen only when the ignition is off |
