| –
| Cut off tube nozzle at forward marking (nozzle approx. 3 mm). |
| –
| Apply silicone sealing compound, as shown, to clean sump sealing surface. Sealing compound bead must be: |
| t
| and run on inside of bolt holes -arrows-. |
Note! | The sealing compound bead must not be thicker, otherwise excessive sealing compound will enter the sump and may block the oil suction pipe strainer. |
| –
| Install sump immediately and tighten all sump bolts lightly. |
| –
| Tighten sump bolts to 15 Nm. |
Note! | After installing sump the sealant must be allowed to dry for approx. 30 minutes before engine oil is filled. After this time has passed, the sump may be filled. |
| The rest of the assembly is basically a reverse of the dismantling sequence. |
|
|
|
