seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil supply line and the support of the turbocharger: Removing and installing > < Checking oil pressure

Leon Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
   
Removal:
–  Loosen the engine cover at the locations -arrows- and remove.
  E10-10087
Altea - Altea XL - Leon
–  Remove crankcase breather hose -1-, press release buttons for this.
–  Free vacuum hoses -arrows-.
–  Release hose clips -3- and pull air hose off air filter housing.
–  Unscrew bolt -2-, swing intake hose and intake unions to rear and pull off of turbocharger.
  A21-10437
Ibiza
–  Version for cold climate zones: Unplug electrical connector -2-.
–  Press release tabs and detach crankcase breather hose -1-.
–  Disconnect vacuum hose -arrow-.
–  Remove the air pipe from the air filter housing, release the hose clip -4- for this purpose.
–  Unscrew the screw -3-, swing air pipe with intake hose to the rear and pull off from the turbocharger.
  A21-10541
All other vehicles continued
–  Remove bolts -2- and -3-, and detach engine lifting eye -1-.
–  Unplug electrical connector -arrow-.
–  Unscrew the oil pressure switch -F1-.
Installation
l  Tightening torques → Fig. → Item
Installation is carried out in reverse order, noting the following:
  Note
Renew seal.
–  Install vacuum line to exhaust gas recirculation cooler.
–  Install intake pipe.
  A17-10550

Oil supply line and the support of the turbocharger: Removing and installing > < Checking oil pressure