Leon Mk2
| Assembly overview - oil pump, sump |
| 1 - | Oil level/oil temperature sender -G266- |
| q | Black connector, 3-pin |
| q | removing and fitting → Chapter |
| 2 - | O ring |
| q | Replace |
| 3 - | Oil drain plug, 30 Nm |
| 4 - | Seal |
| q | Replace |
| 5 - | Bolt. |
| q | Specified torques and installation sequence → Fig.. |
| 6 - | Oil pan |
| q | Clean sealing surface before installing |
| q | Install with silicone sealant -D 176 404 A2-. |
| q | Removing and installing → Chapter. |
| 7 - | 15 Nm |
| 8 - | Oil pump: |
| q | removing and fitting → Chapter |
| q | With pressure relief valve 12 bar |
| q | Before installing, check that both dowel sleeves for centring oil pump on cylinder block are fitted. |
Note| t | If toothed belt or oil pump have to be removed. |
| t | Check the correct operation of the oil pump. |
| t | It should be possible to turn belt pulley easily with 1 finger. |
| t | Replace if binding. |
| 9 - | Toothed belt for oil pump |
| q | Check for damage and wear |
| q | Replace if necessary |
Note| t | Belts which have been in use longer can sag. |
| t | This is not a fault and does not necessarily mean belt needs replacing. |
| 10 - | Dowel sleeves |
| 11 - | cylinder block |
| 12 - | O ring |
| q | Replace |
| 13 - | 9 Nm |
| 14 - | Clip |
| 15 - | Dipstick guide tube |
| 16 - | 9 Nm |
| 17 - | Suction pipe |
| q | Clean strainer if dirty |
| 18 - | Oil separator |
| 19 - | 16 Nm |
| 20 - | Bolt. |
| q | Self-locking |
| q | Replace |
| q | 9 Nm |
Note
|
|
| stage: | Bolts | Tightening torque |
| 1. | -1 … 20- | diagonally, 5 Nm |
| 2. | -Arrows - | 40 Nm with the wrench -T10058- |
| 3. | -1 … 20- | Tighten in stages and in diagonal sequence; final torque 13 Nm. |
Note
|
|
