Leon Mk2
Vehicles with dual-mass flywheel - sealing flange on flywheel side - Assembly overview |
1 - | 60 Nm + 1/4 turn (90°) further |
q | Replace |
2 - | Dual-mass flywheel |
q | removing and fitting → Chapter |
q | Assembly through offset holes only possible in one position. |
3 - | Generator wheel: |
q | For engine speed sender -G28- |
q | removing and fitting → Chapter |
4 - | Engine speed sender -G28- |
q | removing and fitting → Chapter |
5 - | 4.5 Nm |
6 - | Locking pin |
q | 2 units |
7 - | Intermediate plate |
q | Must seat on dowel pins. |
q | Do not damage or bend when assembling. |
q | Engaging on sealing flange → Fig. |
8 - | Sealing flange (gearbox end) |
q | replace → Chapter |
q | With sender wheel for engine speed. |
q | Renew complete only. |
q | Do not additionally oil or grease the oil seal sealing lip. |
q | Before fitting, clean the remains of oil on the crankshaft journal using a clean cloth. |
q | Use support sleeve supplied when installing. |
9 - | Bolt. |
q | Specified torques and installation sequence → Fig.. |
|
|
|