Leon Mk2
Rear silencer: Exploded view of components |
1 - | of the diesel particle filter |
2 - | Trim cap, 40 Nm |
3 - | Retaining ring |
q | Replace if damaged |
4 - | 25 Nm |
5 - | Separating point |
q | Marked by impressions on exhaust pipe. |
q | As standard, exhaust pipe and silencer are installed as a single component. For repairs, exhaust pipe and silencer are supplied with a clamp separately |
q | Cut the connecting pipe vertically in the cutting area -arrow A- using the chain-type pipe cutter -VAS 6254- or the body saw -VAG 1523B- (Wear protective goggles) → Chapter |
q | When fitting, position the repair double clamp on the markings -arrows B- on the side. |
q | Evenly tighten threaded connections of clamping sleeve (repair double clamp), tightening torque: M 8 = 25 Nm, M10 = 40 Nm |
q | Align exhaust system when it is cold so it is free of stress before tightening → Chapter |
6 - | Silencers |
7 - | Retaining ring |
q | Replace if damaged |
8 - | 25 Nm |