Use torque wrench -V.A.G 1331- with spanner from tool set -T10395/6- to tighten. |
WARNING The torque wrench -V.A.G 1331- must be set to 29 Nm in this case. |
Extending the torque wrench -V.A.G 1331- with the spanner from tool set -T10395/6- allows the correct torque of 45 Nm to be achieved. |
|
Lubricate thread of sender using high-temperature paste -G 052 112 A3-. |
Tightening torque for exhaust temperature sender 4 -G648- downstream of non-engine-mounted particulate filter (right-hand drive vehicles) |
|
|
|