Reading and clearing engine control unit fault memory |
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter |
Special tools and workshop equipment required |
t
| Vehicle diagnostic, testing and information system -VAS 505X-, see equivalent → Anchor |
–
| Connect the self diagnosis -VAS 505X- as described below: |
–
| Start engine and allow to idle. |
Only when engine does not start: |
–
| Switch on the ignition. |
–
| Touch the pushbutton for the „vehicle self-diagnosis“ on the display. |
–
| Touch the screen on „01 - Engine electronics“. |
The control unit identification and engine control unit coding are indicated on display. |
Select diagnostic function |
–
| Press button „004 - Reading fault memory content“ on display. |
–
| If faults are stored in the engine control unit, they will be displayed as a list. |
–
| If faults are stored in the engine control unit, they are shown one below the other on the display. |
–
| Press ← button several times. |
–
| Call-up display „1001 Common services“. |
–
| Press button „1001.05 - Clear fault memory“ on display. All OBD systems. |
–
| Exit „vehicle self-diagnosis“ by pressing the ↑ button »End«. |
|
|
|