Leon Mk2
| Assembly overview - toothed belt drive |
| 1 - | Toothed belt guard upper part |
| 2 - | Toothed belt |
| q | Mark direction of rotation before removing. |
| q | Check for wear. |
| q | Do not kink. |
| q | Removing, installing and tensioning → Chapter. |
| 3 - | 20 Nm + 1/8 turn (45°) further |
| 4 - | Tensioning roller |
| 5 - | 100 Nm |
| 6 - | 25 Nm |
| 7 - | Camshaft pulley |
| 8 - | Hub |
| q | With sender wheel |
| q | Use counterhold tool -T10051- to loosen and tighten. |
| q | To remove, use puller -T10052- |
| q | Removing and installing → Chapter. |
| 9 - | 10 Nm |
| 10 - | Rear toothed belt guard |
| 11 - | Sealing grommet |
| q | Renew if damaged |
| 12 - | Toothed belt tensioner |
| q | Only for vehicles with hydraulic tensioning system |
| 13 - | Idler roller |
| 14 - | Coolant pump |
| q | Installed in cylinder block |
| q | Check for ease of movement. |
| q | Note installation position. |
| q | Removing and installing → Chapter. |
| 15 - | Crankshaft toothed belt pulley |
| 16 - | 120 Nm + 1/4 turn (90°) further |
| q | Renew. |
| q | Use counterhold for toothed belt pulley -3099- to loosen and tighten |
| q | Do not additionally oil or grease the threads and shoulder |
| q | Turning further can be done in several stages. |
| 17 - | 15 Nm |
| 18 - | 20 Nm |
| 19 - | Toothed belt guard lower part |
| 20 - | Belt pulley and vibration damper |
| q | Can only be installed in one position, holes are offset. |
| 21 - | 10 Nm + 1/4 turn (90°) further |
| 22 - | Cover |
| q | Fitted according to version |
| 23 - | Toothed belt guard centre part |
| 24 - | 30 Nm |
| 25 - | 45 Nm |
| 26 - | Engine support |
| 27 - | 45 Nm |
