seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Diagram of coolant hose connections > < Oil supply line and the support of the turbocharger: Removing and installing

Leon Mk2

Removing and installing parts of cooling system
Removing and installing parts of cooling system
→ Chapter „Diagram of coolant hose connections“
→ Chapter „Draining and filling cooling system“
→ Chapter „Coolant pump and thermostat: component overview“
→ Chapter „Removing and installing coolant pump“
→ Chapter „Removing and installing 4/2-way valve with thermostat“
→ Chapter „Pipes, temperature sender, pump for the coolant circulation component overview“
→ Chapter „Removing and installing coolant temperature sender -G62-“
→ Chapter „Removing and installing coolant temperature sender at radiator outlet -G83-“
→ Chapter „Removing and installing coolant circulation pump 2 -V178-“
→ Chapter „Radiator and radiator fan: component overview“
→ Chapter „Removing and installing radiator“
→ Chapter „Removing and installing electrical radiator fan -V7- and radiator fan -2- -V177-“
→ Chapter „Cooling system: checking for leaks“
  WARNING
When opening the expansion tank, extremely hot vapour may be released; cover the cap with a cloth and open carefully.
  Note
t  When the engine is hot the cooling system is under pressure. If necessary, relieve pressure before commencing repair work.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue.
t  The use of a hose clip pliers -VAS 6499- is recommended for fitting spring-type hose clips.
t  Renew gaskets and seals.
t  The arrow markings on the coolant pipes and on the ends of the hoses must be aligned with each other.
   

Diagram of coolant hose connections > < Oil supply line and the support of the turbocharger: Removing and installing