SEAT Workshop Service and Repair Manuals

Removing and installing coolant circulation pump 2 -V178- t  Removing → Anchor t  Fitting → Anchor t  Specified torques → Anchor.

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Hose clamp -3094-, see equivalent → Anchor

t	Collecting tray -VAS 6208-, see equivalent → Anchor

t	Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

Removing –  Unscrew the securing bolts -arrows- and remove the engine soundproofing..

–  Loosen the angled bracket -1- and -2- and remove the right hose from the charged air cooler.

–  Remove bolts -arrows-. –  Release hose clip -2- and push front air intake pipe towards the right.   Note Disregard -item 1, 3-.

–  Disconnect and remove the coolant hoses using the hose clip -3094-. For this purpose, loosen the clip -2-. –  Disconnect connector -arrow-. –  Unscrew the bolts -4- and remove the coolant circulation pump 2 -V178--3-.   Note Disregard -item 1-. Fitting Installation is carried out in the reverse order; note the following:   Note t  Hose connections and air pipes and hoses must be free of oil and grease before assembly. t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue. t  To ensure that the air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing. –  Install air pipe at the front.

–  Mount the soundproofing of the engine and insert the securing bolts -arrows-. –  Check coolant level → Chapter. Tightening torques

Component		Nm
Fixing screws coolant circulation pump 2 -V178-		5
Bolts of the turbocharger hose		10