seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Checking the supercharger system for leaks > < Removing and installing charge air cooler

Leon Mk2

Removing and installing charge air pressure senderG31 / intake air temperature senderG42
Removing and installing charge air pressure sender -G31- / intake air temperature sender -G42-
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench -VAG 1331-, see equivalent → Anchor.
  W00-0427
Removing
–  Unscrew the securing bolts -arrows- and remove the engine soundproofing..
  E10-0086
–  Disconnect connector -2-.
–  Remove the bolts -1- and pull charge air pressure sender -G31-/intake air temperature sender -G42- out of air pipe.
Fitting
l  Specified torque → Chapter.
Installation is carried out in the reverse order; note the following:
  Note
Renew O-ring.
–  Fit the centre sound proofing → Exterior body installation work; Rep. gr.50 .
  A21-10436

Checking the supercharger system for leaks > < Removing and installing charge air cooler