| Fuel preparation, Assembly instructions, 2.0l Common Rail engine |
| Only the respective tools should be used for loosening / tightening the bolts, nuts and brackets on the complete CR system. |
| All other fitting work should be performed by hand. |
| The components of the CR system should not be dismantled. |
| Should a component display a fault, it must be completely replaced. |
| Never loosen high-pressure components after starting the engine to bleed the common rail system. |
| Assembly work on the CR system should not be performed when the engine is running. This especially applies to opening / loosening the high pressure lines. |
|
|
|
