seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Notes on installing > < Removing engine

Leon Mk2

Securing engine to assembly stand
Securing engine to assembly stand
When working on the engine, secure it with engine and gearbox support -VW 540- to support clamp -VW 313- of the assembly stand or to engine and gearbox support -VAS 6095-.
Procedure
–  Remove gearbox.
Vehicles with automatic gearbox
–  Secure torque converter against “falling out” after separating engine from gearbox.
Continuation for all vehicles
   
–  Attach lifting tackle -2024 A- as follows and lift from engine and gearbox jack -V.A.G 1383 A- using workshop crane -1202 A- or workshop crane -VAS 6100-.
Belt pulley end: 1st hole of hook rail in position 1
Flywheel end: 4th hole in hook rail at position 8.
  WARNING
The hooks and locating pins must be secured with locking pins.
  Note
t  The positions marked 1...4 on the bar must be towards the pulley end.
t  The holes in the hooks are counted up from the hook.
–  Secure engine to support clamp -VW 313- using engine and gearbox support -VW 540- or to engine and gearbox support -VAS 6095-.
  Note
First loosen coolant pipe at flywheel end.
  N10-0206

Notes on installing > < Removing engine