Leon Mk2
Assembly overview - parts of cooling system, engine side |
1 - | To exhaust gas recirculation cooler. |
q | Coolant hose schematic diagram → Chapter. |
2 - | To auxiliary heater (if fitted) |
q | Coolant hose schematic diagram → Chapter. |
3 - | From heat exchanger |
q | Coolant hose schematic diagram → Chapter. |
4 - | To heat exchanger |
q | Coolant hose schematic diagram → Chapter. |
5 - | From exhaust gas recirculation cooler |
q | Coolant hose schematic diagram → Chapter. |
6 - | Continued coolant circulation pump -V51- |
7 - | From auxiliary heater (if fitted) |
q | Coolant hose schematic diagram → Chapter. |
8 - | 15 Nm |
9 - | Connection |
q | Fitted at cylinder block |
10 - | To cylinder head |
11 - | Expansion tank |
q | Perform leak test of cooling system with cooling system tester -V.A.G 1274- and adapter -V.A.G 1274/8- → Chapter. |
q | Observe markings → Chapter |
12 - | Seal |
q | Observe installation position on cap |
q | Renew if damaged. |
13 - | Cap |
q | Check using cooling system tester -V.A.G 1274- and adapter -V.A.G 1274/9- → Chapter |
14 - | 10 Nm |
15 - | Coolant pipe |
16 - | O-ring |
q | Renew if damaged. |
17 - | Upper coolant hose |
q | Coolant hose schematic diagram → Chapter. |
18 - | Lower coolant hose |
q | Coolant hose schematic diagram → Chapter. |
19 - | Connection |
q | For thermostat. |
20 - | O-ring |
q | Renew |
21 - | Thermostat |
q | Removing and installing → Chapter. |
q | Note installation position → Chapter. |
q | Checking: heat thermostat in water. |
q | Opening begins at approx. 87 °C. |
q | Ends at approx. 102 °C. |
q | Opening lift min. 7 mm. |
22 - | Oil cooler |
23 - | Coolant pump |
q | Installed in cylinder block |
q | Check for ease of movement. |
q | Note installation position. |
q | Removing and installing → Chapter. |
24 - | Seal |
q | Renew |
25 - | Securing clip |
q | Check for secure seating. |
26 - | Coolant temperature sender -G62- |
q | If necessary, release pressure in cooling system before removing |