t
| Torque wrench -V.A.G 1331- |
Caution If the intermediate gear wheel bolt was loosened, the drive gear wheel on crankshaft was renewed or the crankshaft was removed, a new intermediate gear wheel with coating must be installed and the hub → Item with bolt → Item and thrust washers must be renewed, otherwise the tooth backlash is incorrect. Procedure when installing → Chapter. |
|
Note t
| Proceed as follows if the previously used balancer shaft module is being reinstalled and the drive gear wheel on the crankshaft or the crankshaft have not been replaced. The intermediate gear wheel must also not have been loosened. |
t
| Renew the bolts tightened with specified tightening angle. |
|
|
|