Leon Mk2
Assembly overview - crankcase |
1 - | Cylinder block |
q | Removing and installing sealing flange and flywheel/drive plate → Chapter. |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter |
q | Assembly overview - balancer shaft module → Chapter |
2 - | Gasket |
q | Renew |
3 - | Oil filter bracket |
q | Ensure clearance to adjacent components. |
q | Assembly overview - oil filter bracket → Chapter |
4 - | 15 Nm + 1/4 turn (90°) further |
q | Renew |
q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
5 - | Connection |
q | For thermostat. |
6 - | 15 Nm |
7 - | O-ring |
q | Renew |
8 - | Thermostat |
q | Removing and installing → Chapter. |
q | Note installation position → Chapter. |
q | Checking: heat thermostat in water. |
q | Opening begins at approx. 87 °C. |
q | Ends at approx. 102 °C. |
q | Opening lift min. 7 mm. |
9 - | 45 Nm |
q | Observe tightening sequence → Fig. |
10 - | Compact bracket |
q | For alternator, power steering vane pump and air conditioner compressor |
11 - | Sump |
q | Clean sealing surface before fitting. |
q | Install with silicone sealant -D 176 404 A2-. |
q | Removing and installing → Chapter. |
12 - | 15 Nm |