A - Assembling sealing flange with sender wheel on assembly appliance T10134
A - Assembling sealing flange with sender wheel on assembly applianceT10134
A - Assembling sealing flange with sender wheel on assembly appliance -T10134-
–
Screw in hexagon nut -B- to just before clamping surface -A- of threaded spindle.
–
Clamp assembly device -T10134- in a vice on clamping surface -A- of threaded spindle.
–
Press assembly bell housing -C- downwards so that it lies on hexagon nut -B--arrow-.
Note
Inner part of assembly tool and assembly housing must be at same height.
–
Remove securing clip -arrow- from new sealing flange.
Note
The sender wheel must not be taken out of the sealing flange or turned.
–
Locating hole -A- on sender wheel -C- must align with marking -B- on sealing flange.
–
Place sealing flange with front side downwards on a clean flat surface.
–
Push sealing lip support ring -A- downwards in direction of arrow until it lies on flat surface.
–
Upper edge of sender wheel and front edge of sealing flange must align -arrows-.
–
Place sealing flange with front side on assembly tool -T10134- so that locating pin -A- can be inserted in sender wheel hole -A-.
Note
Ensure sealing flange lies flat on assembly tool.
–
Push sealing flange and support ring for sealing lip -B- against surface of assembly tool -T10134- whilst tightening the three knurled screws -A- so that locating pin cannot slide out of sender wheel hole.
Note
When installing sealing flange, ensure that sender wheel remains fixed in assembly device.