Leon Mk2
Assembly overview - fuel filter |
1 - | Fuel line |
2 - | O-ring |
q | Renew |
3 - | Regulating valve |
q | Installation position: arrow points towards fuel tank |
q | When changing filter, remove retaining clip and take off regulating valve with fuel hoses still attached. |
q | Below + 15 °C: Passage to filter open |
q | Over + 31 °C: Passage to filter closed |
4 - | Securing clip |
q | Check for secure seating. |
5 - | Return line |
q | To fuel cooler |
q | Clipped onto bulkhead |
q | Blue or with blue marking. |
q | Check for secure seating. |
6 - | Supply line |
q | From fuel tank. |
q | Clipped onto bulkhead |
q | White or with white marking. |
q | Check for secure seating. |
7 - | Fuel filter |
q | Fill with diesel fuel before installing |
q | Direction of flow is marked with arrows. |
q | Do not interchange connections. |
q | Renew if damaged. |
8 - | Gasket |
q | Renew if damaged. |
9 - | Water drain screw |
q | To bleed remove regulating valve securing clip and remove regulating valve complete with connected fuel lines. |
q | Loosen and allow approx. 100 cm3 fluid to drain |
10 - | Return line |
q | From tandem pump → Item |
q | Check for secure seating. |
q | Blue or with blue marking. |
11 - | Connection |
12 - | Fuel temperature sender -G81- |
13 - | O-ring |
q | Renew if damaged. |
14 - | Supply line |
q | Check for secure seating. |
q | To tandem pump → Item. |
q | White or with white marking. |