Leon Mk2
Engine cooling system components |
1 - | 15 Nm |
2 - | Coolant pump |
q | Check for ease of movement |
q | Note fitting position: |
q | removing and fitting → Chapter |
3 - | O-ring |
q | replace |
4 - | Towards the upper part of the expansion tank |
q | Coolant hose schematic diagram → Chapter |
5 - | Upper metal tube for coolant |
q | Screwed onto cylinder head cover |
q | Coolant hose schematic diagram → Chapter |
6 - | Joint mouth |
q | For the heat exchanger |
7 - | Distribution element |
8 - | Coolant temperature sender -G62- |
q | With Coolant temperature sender -G2- |
9 - | Retaining clip |
q | Ensure correct seating |
10 - | O-ring |
q | replace |
11 - | Distribution element |
12 - | Joint mouth |
13 - | 10 Nm |
q | 2x |
14 - | Distribution element |
15 - | 40 Nm |
16 - | To radiator by the upper part |
q | Coolant hose schematic diagram → Chapter |
17 - | Metal pipe for Coolant |
q | Coolant hose schematic diagram → Chapter |
18 - | Towards the lower part of the expansion tank |
q | Coolant hose schematic diagram → Chapter |
19 - | To radiator, down |
q | Coolant hose schematic diagram → Chapter |
20 - | Joint mouth |
q | For thermostat |
21 - | Coolant thermostat: |
q | removing and fitting → Chapter |
q | Note the fitting position, → Chapter |
q | Check: Heat the thermostat in water |
q | Starts opening at approx. 85 ? |
q | Ending approx. 105 °C |
q | Minimum opening distance 7 mm |
22 - | Oil cooler |
q | removing and fitting → Item |