Leon Mk2
| Sealing flange and flywheel: Assembly overview, engine code BMT |
| 1 - | Seal |
| q | Do not grease or oil the seal lip of the seal |
| q | Before fitting, clean the remains of oil on the crankshaft pivot using a clean cloth. |
| q | Renewing crankshaft oil seal on pulley end → Chapter |
| 2 - | Sealing flange on the pulley side |
| q | Must sit on dowel sleeves |
| q | removing and fitting → Chapter |
| q | Fit with silicon-based sealant → Parts Catalogue → Chapter |
| 3 - | cylinder block |
| q | Crankshaft: removing and fitting → Chapter |
| q | Piston and con-rods: dismantling and assembling → Chapter |
| 4 - | 60 Nm + 90° turn a further (1/4 rotation) |
| q | 6x |
| q | replace |
| 5 - | Flywheel |
| q | To remove and fit the engine flywheel, immobilise it using the retention tool -T20176- → Chapter |
| 6 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage/bend when assembling |
| 7 - | 15 Nm |
| q | replace |
| 8 - | Sealing flange with sealing ring |
| q | Only replace the unit complete with the sealing ring and sender wheel |
| q | removing and fitting → Chapter |
| 9 - | Engine speed sender -G28- |
| q | Unfasten and tighten with a conventional Allen key with spherical head. |
| q | Tightening torques: 5 Nm |
| q | removing and fitting → Chapter |
