| Exhaust system components: Installing and removing: |
Note | t
| The connection element on the primary exhaust tube should not be bent more that 10 º, otherwise it may be damaged. |
| t
| After completing work on the exhaust system ensure that it is tension-free and remains at a sufficient distance from the bodywork. If necessary, loosen the double and securing clamps and position the silencer and exhaust tube in such a way that there is sufficient distance from the body and the supports are evenly loaded → Chapter. |
| t
| Exhaust manifold: removing and fitting → Chapter |
| t
| Renew self-locking nuts. |
| t
| Exhaust system components: Assembly overview. → Chapter |
| t
| Exhaust pipe front section with particle filter: Assembly overview → Chapter (Engine code BMT) |
| t
| Exhaust pipe front section with particle filter: Removing and installing → Chapter (Engine code BMT) |
| t
| Lambda probe -G39-: Removing and installing → Chapter (Engine code BMT) |
| t
| Sender 2 for exhaust gases temperature -G448-; Removing and installing (Engine code BMT) → Chapter |
| t
| Temperature sensor behind particle filter -G527-: Removing and installing (Engine code BMT) → Chapter |
| t
| Exhaust gas installation: Align free of tension → Chapter |
| t
| Exhaust system: checking for leaks → Chapter |
|
|
|
