Leon Mk2
Oil filter and oil cooler - exploded view |
1 - | Screw plug, -40 Nm |
2 - | Seal |
q | Replace |
3 - | Spring |
q | For pressure relief valve, approx. 4 bar |
4 - | Piston |
q | For pressure relief valve, approx. 4 bar |
5 - | Seal |
q | Replace |
6 - | Oil retention valve: |
q | removing and fitting → Fig. |
7 - | O ring |
q | Replace |
q | Fit on oil retention valve → Item |
8 - | O ring |
q | Replace |
q | Slide on as far as the pipe collar → Item |
9 - | Tube |
q | For crankcase ventilation. |
10 - | Retaining clip |
11 - | Screw plug, 15 Nm |
12 - | Seal |
q | If seal is leaking, cut open and renew. |
13 - | Oil pressure switch -F1- 1.4 bar - 25 Nm |
q | Black insulation |
q | Checking → Chapter |
14 - | Seal |
q | If seal is leaking, cut open and renew. |
15 - | 15 Nm + 90° (1/4) turn further |
q | Replace |
16 - | Seal |
q | Replace |
q | Engage in projections on oil cooler |
17 - | Oil filter |
q | Heed replacement intervals → Booklet301 |
q | Observe installation instructions on oil filter. |
q | Tighten to 20 Nm |
18 - | 25 Nm |
19 - | Oil cooler |
q | See note → Chapter |
q | Ensure clearance from surrounding components |
q | Coolant hose schematic diagram → Chapter |
20 - | Oil filter bracket |
q | For pressure relief valve, approx. 4 bar |
q | removing and fitting → Chapter |