seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling pistons and conrods > < Needle bearing on the crankshaft: Removing and installing

Leon Mk2

Removing and installing drive pinion
Removing and installing drive pinion
t  Removing → Anchor
t  Installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Adjustment sleeve -30-100-, see equivalent → Anchor
  W00-0359
t  Compression tool -40-105-, see equivalent → Anchor
t  Current two armed extractor
t  Protective gloves
  W00-0113
Removing
l  Engine removed → Chapter.
–  Remove sump → Chapter.
–  Remove front sealing flange → Chapter.
–  Remove drive chain for oil pump → Item and chain tensioner → Item.
–  Remove gear with standard commercial puller -2- while protecting crank journals with compression tool -40-105--1-.
  A13-0058
Installing
  WARNING
Wear protective gloves!
–  Heat the chain sprocket in the oven for about 15 minutes at 220 ºC.
–  Fit chain sprocket on end of crankshaft using pliers.
l  Fitting position: The broad collar of the sprocket wheel points towards the engine.
–  Push sprocket onto crankshaft as far as the stop using drift sleeve -30-100-.
  A13-0059

Dismantling and assembling pistons and conrods > < Needle bearing on the crankshaft: Removing and installing