Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
t
Torque wrench -VAG 1331-, see equivalent → Anchor.
t
Torque wrench -VAG 1332-, see equivalent → Anchor.
Removing
–
Disconnect activated charcoal reservoir solenoid valve 1 -N80--1- from air duct.
–
Remove bolts -arrows-.
–
Remove air duct -2-.
Note
Before removing the Poly-V belt, mark the direction of rotation using chalk or a marker. If the belt runs in the opposite direction when it is refitted, this can cause breakage.
–
Release tensions on poly V belt by turning tensioning element in direction indicated by -Arrow-.
–
Take off poly V-belt.
–
Remove pulley from crankshaft.
Note
To loosen and tighten the crankshaft pulley, lock with ring spanner on centre bolt.
Installing
–
Reassembly is carried out in the reverse order; note the following:
Note
Fitting can only be completed in one position only: The borehole -arrow- in the pulley must be positioned above the raised section of the toothed belt sprocket.