Leon Mk2
| Fuel tank with attached components - exploded view |
Note| The illustration shows a fuel system with fuel return line. |
| 1 - | Fuel supply line |
| q | From fuel filter. |
| q | To engine. |
| q | Do not bend |
| q | To disengage, press the clip in the joint to unlock it |
| 2 - | Fuel return line |
| q | From engine |
| q | Do not bend |
| q | To disengage, press the clip in the joint to unlock it |
| q | Install on fuel tank |
| 3 - | Breather line |
| q | Leading to activated charcoal filter in wheel housing (front right) |
| q | Do not bend |
| q | To disengage, press the clip in the joint to unlock it |
| q | Install on fuel tank |
| 4 - | 23 Nm |
| q | Secures fuel filler neck and earth connection → Item |
| 5 - | Overflow hose |
| q | Engage in wheel housing |
| 6 - | Rubber cup |
| 7 - | Tensioning ring |
| 8 - | Seal |
| q | If this is damaged, replace it |
| 9 - | Sealing plug |
| q | Secured to tank flap |
| 10 - | Earth connection |
| q | To deflect the electrostatic charges |
| q | Installation position (testing instructions) |
| q | Ensure that connector is seated properly and secure wire with securing bolt for fuel filler neck → Item |
| q | After installation check electrical connection between sheet metal ring on fuel filler fitting and bare spot on body with ohmmeter. Specification: approx. 0 Ω. |
| 11 - | Breather line |
| 12 - | Fuel tank |
| q | Removing and installing |
| 13 - | Heat shield |
| q | For fuel tank. |
| 14 - | 2 Nm |
| 15 - | Heat shield |
| q | For fuel tank. |
| 16 - | 2 Nm |
| 17 - | Spreader clip |
| 18 - | tension belt |
| q | Note different lengths |
| 19 - | 23 Nm |
|
|
Caution