seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant circulation pump 2V178 > < Removing and installing coolant temperature senderG62

Leon Mk2

Removing and installing coolant temperature sender at radiator outletG83
Removing and installing coolant temperature sender at radiator outlet -G83-
t  Removing → Anchor.
t  Installing → Anchor.
Removing .
l  Engine cold
–  Briefly open filler cap for coolant expansion tank in order to reduce pressure in cooling system.
   
–  Remove the engine cover upwards -arrows-.
  E10-10085
–  Loosen bolt -1-.
–  Unscrew bolt -2- and nut -3-.
–  Take hose retainer -4- off fuel filter, place fuel filter -7- aside (fuel hoses -5- and -6- remain connected).
  A20-10395
–  Unplug the plug connector -2- of the radiator outlet coolant temperature sender -G83-.
  Note
Place a cloth underneath to catch escaping coolant.
–  Pull off retaining clip -1- and pull coolant temperature sender at radiator outlet -G83- out of screw connection of coolant pipe.
Installing .
Installation is carried out in the reverse order; note the following:
  Note
t  Renew O-ring.
t  Insert new radiator outlet coolant temperature sender -G83- immediately into coolant pipe to avoid loss of coolant.
–  Install fuel filter → Chapter.
–  Check coolant level → Chapter.
  A19-10745

Removing and installing coolant circulation pump 2V178 > < Removing and installing coolant temperature senderG62