seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
removing and installing the air conduit tube > < Installation instructions, charge air pipes

Leon Mk2

Charge air system with one charge air cooler: Assembly overview
Charge air system with one charge air cooler: Assembly overview
  Note
In engines with the engine code CAGA, the right charged air cooler is no longer required from 09.2009.
–  Observe rules for cleanliness → Chapter.
   
1 - Air duct
q   To lock carrier and turbocharger
q   Remove all oil and grease before installing
q   removing and fitting → Rep. gr.50
2 - Air hose
q   To turbocharger
q   Must be free of oil and grease when installing
3 - Air pipe
q   removing and fitting → Chapter
4 - 8 Nm
5 - Metal clamp
q   Tightening torque → Fig.
6 - Air hose
q   To the lock carrier plate
q   Remove all oil and grease before installing
7 - Air hose
q   To intake manifold
q   Remove all oil and grease before installing
8 - O ring
q   Replace
9 - Charge air pressure sender -G31-
q   removing and fitting → Chapter
q   Only in charge air cooler (left-side)
10 - 5 Nm
11 - Mounting
12 - Bracket for charge air cooler (left-side)
13 - Rubber grommet
14 - 22 Nm
15 - Charge air cooler (left-side)
q   removing and fitting → Chapter
16 - Air duct
q   For charge air cooler (left-side)
17 - Air hose
q   To charge air cooler (left-side)
q   Remove all oil and grease before installing

   
Install air hoses with screw clamps.
  Note
To secure the air hoses properly at their connections, spray rust remover onto the worm thread of the used hose clips before installing.
Specified torques for
1 - Hose clamp-a- = 13 mm wide: 5.5 Nm
2 - Hose clamp-b- = 9 mm wide: 3 Nm
  A21-10396

removing and installing the air conduit tube > < Installation instructions, charge air pipes