seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Radiator fan: Removing and installing > < Removing and installing radiator

Leon Mk2

Air supply of the radiator fan: Removing and installing
Air supply of the radiator fan: Removing and installing
Removal:
   
–  Pull off engine cover panel -arrows-.
–  Move lock carrier to service position → Rep. gr.50.
  E10-10062
–  Detach connectors -1- and -2- from bracket and unplug connectors.
–  Move electrical wiring clear.
  A10-10282
–  Thread off the screws -arrows- and remove the air supply of the radiator fan upwards.
Installation
Reassembly is carried out in the reverse order; note the following:
–  Install the lock carrier.
  A19-10153
–  The torque reaction support must set itself on its rubber stop by means of its self weight, then tighten the nuts -arrows-.
–  Fit the front bumper cover → Exterior body installation work; Rep. gr.63.
–  Check headlight adjustment → Booklet301.
Tightening torques
  A10-10298
Components:Nm
Ventilator ductingM611
on the lock carrierSelf-tapping screw2
Stop for torque reaction support28
Hose clips (9 mm wide)3
Hose clips (13 mm wide)5,5

   

Radiator fan: Removing and installing > < Removing and installing radiator