To prevent damage to the dual-mass flywheel when removing, the bolts -B- must not be removed with an impact wrench or similar. The bolts should only be removed by hand.
–
Rotate the dual-mass flywheel -A- so that bolts-B- are aligned with the holes -arrows-.
–
When unscrewing the bolts -B-, ensure that the head of the bolt does not rest on the dual-mass flywheel -arrows-, as it would get damaged when turning.
–
Insert the counterhold -3067- into the hole in the engine block-B-.
–
Mark dual-mass flywheel with respect to engine.
–
Unscrew dual-mass flywheel.
Installing
Reassembly is carried out in the reverse order; note the following:
–
Secure with new bolts.
–
Insert the counterhold -3067- into the hole in the engine block-A-.