Leon Mk2
|
| 1 - | 15 Nm |
| 2 - | Seal |
| q | replace → Chapter |
| q | Do not use oil |
| 3 - | Sealing flange on the pulley side: |
| q | Must sit on dowel sleeves |
| q | removing and fitting → Chapter |
| q | For removing and installing, detach the oil sump → Chapter |
| 4 - | cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Piston and rod: disassembly and assembly → Chapter |
| 5 - | 60 Nm + 90° (1/4 turn) |
| q | Replace |
| 6 - | Dual mass flywheel or drive plate |
| q | Removing and installing dual-mass flywheel → Chapter. |
| q | Drive plate: removing and installing → Chapter |
| q | Assembly is possible only in one position, as the holes are offset |
| 7 - | Intermediate plate |
| q | Must sit on dowel sleeves |
| q | Do not damage or bend when assembling. |
| q | Is fitted onto sealing flange → Fig. |
| 8 - | 15 Nm |
| 9 - | Sealing flange on flywheel side |
| q | Can be replaced complete with oil seal. |
| q | Use the provided guide sleeve for installation. |
| q | For removing and installing, detach the oil sump → Chapter |
| q | Do not grease or oil the seal lip of the seal |
| q | Before fitting, clean the remains of oil on the crankshaft journal using a clean cloth. |
| q | The guide sleeve should only be removed after fixing the sealing flange on the crankshaft journal |
|
| 1 - | Bolt. |
| q | Replace |
| q | Tighten to 60 Nm turn a further 90° |
| 2 - | Dual-mass flywheel |
| q | Removing and installing dual-mass flywheel → Chapter. |
| q | Assembly is possible only in one position, as the holes are offset |
| 3 - | Bolt. |
| q | Tightening torque and sequence → Anchor |
| 4 - | Intermediate plate |
| q | Must seat on dowel pins. |
| q | Do not damage or bend |
| q | Is fitted onto sealing flange → Fig. |
| 5 - | cylinder block |
| 6 - | Locking pin |
| 7 - | Sealing flange - gearbox side |
| q | With shaft seal |
| q | Can only be replaced as one unit |
| q | Do not grease or oil the seal lip of the seal |
| q | To fit, use the guide sleeve provided |
| q | Do not remove guide sleeve until sealing flange has been slipped onto crankshaft journal |
|
|
|
|
